Full 3 port Isolation

Virtually any Type of Input

Ultra compact DIN Rail Enclosures from 7.2mm Wide!

High Noise Immunity

High Accuracy, Low Cost Solution

Single and Dual Output Versions
 

The ISOCON family can cater for signals from 0-50µA to 0-5A, 0-4mV to 0-300V, 0-10ohms to 0-10Mohms, thermocouple types E,J,K,N,R,S,T,B and 2, 3 or 4 wire RTD's. The ISOCON-6 IS configured for a 12Vdc/ac to 36Vdc (32Vac) supply and the ISOCON-3 for 90Vac to 264Vac supply. Both devices have a 24V transmitter supply fitted. The units can be easily configured either by us or the user using the simple built-in switches. There is also an easy to use PC software application to help with the configuration. The ISOCON family has both zero and span buttons on the front panel for easy output calibration and adjustment.DC output of either voltage or current.

The DUALCON family is identical in functionality to the ISOCON family above, except that it has 2 independent and isolated outputs which can be configured separately.

The SLIMCON unit can accept a range of inputs including 4-20mA and voltage signals. The unit produces an isolated high level DC output of either voltage or current. The SLIMCON is very thin at only 7.2mm wide and is highly accurate with a fast time response.

The TC-TC isolator accepts a mV signal from virtually any type of thermocouple and provides an identical isolated mV signal. This helps prevent earth loop and sensor failure problems in multi-thermocouple installations. The unit can be supplied in DC or AC powered configurations.

The STRAIN unit is a Universal Strain Gauge transmitter. It will interface to the majority of strain gauges, load cells and pressure transducers. The unit provides a high stability excitation voltage which is isolated from both the high level output and the power supply. Front panel mounted trim pots allow adjustment of zero and span settings and output monitoring terminals allow the output to be measured without breaking the instrument loop. The STRAIN can be supplied in either AC or DC powered versions.

Note: For input voltages greater than 30Vac or 60Vdc a DIVIDER unit will have to be supplied.